Epson TM-T20II: Network Address Setting for Ethernet Printer

If you are using an Ethernet connection, configure the IP address using the EpsonNet Config

  1. Start the EpsonNet Config
    • When the EpsonNet Config is already installed, start it by clicking Start – All Programs – EpsonNet – EpsonNet Config Vx – EpsonNet Config
  2. The EpsonNet Config screen appears
    • Check that the target printer is listed in the screen
  3. Select the printer you want to configure, then click the Configuration button
    • When the printer does not appear, click the Refreshbutton
  4. The Device Properties screen appears. Select the Network Interface – TCP/IP – Basic
  5. Configure the printer IP address. Then click the Transmit button
    • Select the Manual and Set using PING. Then configure the IP Address, Subnet Mask and Default Gateway
  6. The confirmation screen appears. Click the Yes button
  7. The configured settings are sent to the printer. After approximate 10 to 30 seconds, the completion screen appears. Click the OK button
  8. Confirm the settings on the EpsonNet Config screen
  9. Quit the EpsonNet Config